This Example is for setting the Upper Left corner at Zero. Click Here to Set the Center the Part as Zero

1. First check spindle RPM

2. Press the Manual Machine Mode Button

3. Press the Manual Function SetUp Softkey

4. Look at spindle speed and change if needed

5. Press the Input Button

6. Press the PART SETUP Softkey

7. Put in an edge finder in the spindle – load your part in vise

8. Press the Spindle On then the flashing START CYCLE Button

9. Using the Handwheel Jog over to the left edge of part with edge finder “When Close To Part Use Hand Wheel Only”

10.     Look to see that cursor is at Part Zero X

11.     When cursor is at X Part Zero press the Store Position button above hand wheel

12.     Next move cursor back up to X and type in the following to comp. for edge finder radius  .1 + Enter

13.     Your Part Zero readout  should read  X -.1000 next repeat for Y

14.     Jog the Edge Finder to back Y edge of the part

15.     Verify the cursor is at Part Zero Y

16.     When cursor is at Y Part Zero press the Store Position button above hand wheel

17.     Next move cursor back up to Part Zero Y and type in the following to comp. for edge finder radius  .1 - Enter

18.     Your Part Zero readout  should read  Y .1000

19.     Press the Spindle Off button

20.     Jog the Z up

21.     Remove the tool from the spindle