|
|
- First check spindle RPM
- Press the Manual
Machine Mode Button
- Press the Manual
Function Set Up softkey
- Look at spindle speed and change if needed
- Press the
Input Button
- Press the PART
SETUP Softkey
- Put in an edge finder in the spindle – load your part in vise
- Press the Spindle On then the flashing START
CYCLE Button
- Using the Hand wheel Jog over to the left edge of part with edge finder “When Close to Part Use Hand Wheel Only”
- Look to see that cursor is at Part Zero X
- When cursor is at Part Zero X press the Store Position button above hand wheel
- Your Part Zero readout in the position display should read X 0.000
- Jog the Edge Finder to the right side of the part, look at the Part Zero X position
and take note of the number. On a 6” part is should be around 6.200”
- Verify the cursor is at Part Zero X and type the value in the Part Zero Readout Display
of X and math functions as follows… 6.100
/ 2+Enter. The Part Zero Position for X should read half the value it
was. You just split the difference in the X axis.
- Now using the Hand wheel again jog over to the front edge of part…When Close To Part Use Hand Wheel Only”
- Look to see that cursor is at Part Zero Y
- When cursor is at Part Zero Y press the Store Position button above hand wheel
- Your Part Zero readout in the position display for Y should read Y 0.000
- Jog the Edge Finder to the Back side of the part, look at the Part Zero Y position
and take note of the number. On a 3” part it should be around 3.200”
- Verify the cursor is at Part Zero Y and type the value of Part Zero Readout Display
for Y and math functions as follows…. 3.100/2+Enter
The Part Zero Position for Y should read half the value it was. You just split
the difference on the Y axis.
- Press the Spindle Off button
- Jog the Z up
- Remove the tool from the spindle
|
 |
|
