1. Input
Button
2. Press
the Tool Review Softkey
3. Press
the Setup Softkey
4. Type
in tool number you want to setup and press the Enter button
5. Press
the Tool Changer “Auto”
button
6. Cycle
Start … Tool will change
7. Put
tool in spindle if it is not the correct one
8. Enter
the tool type Endmill Softkey
9. Type
in the tool diameter
10. Jog down to 1” gauge block
11. Store position button
12. Key in 1.0 + Enter
13. Leave the Speed blank
14. Select the coolant Primary
Softkey
15. Surface Feed at 300-1,000 for aluminum
16. Feed per tooth diameter of the tool ÷ by 200
17. Enter the # of flutes
18. Press Tool Home Softkey
19. Press the flashing Start button